Free US / Domestic Shipping On Orders Over $135!

What is the perfect guitar cable length?

At Rattlesnake Cable Company, we often get asked, "what is the perfect guitar cable length?" That is a difficult question to answer without knowing some of the critical variables and applications for the musician. But before we get started, let's start with some of the common questions.

Are long guitar cables bad?

Yes and no. Typically, extremely long guitar cables can be a problem due to cable capacitance. The longer the run, the more capacitance can be encountered. Cable capacitance will darken or muddy your tone. The rate of that capacitance has multiple factors, including the length of the cable, the gauge of the conductor, and the how much internal insulation separates the signal conductor from the shield.

Long cables can be remedied with a signal buffer to get that original signal back. So if a long cable is required, we recommend using a buffer somewhere in the signal chain.

Does guitar cable affect the sound?

Absolutely, the guitar cable can affect the sound. As I mentioned above, capacitance can be an issue. This is highly dependent on the cables you purchase and how they are built. Shorter run cables in the 10-15 feet range are ideal and going 20 feet and longer, you may begin to experience some tone or signal loss. Our cables are engineered to be low capacitance, with the sweet spot being in that 15' range, and 20' still sounds clear and natural.

What is the perfect guitar cable length? Cable from spool

Are thicker guitar cables better?

Thicker guitar cables tend to indicate durability (beefy, as they say). But thicker cables also mean a more significant gap between the signal conductor and the internal shield. This gap is critical for maintaining lower capacitance over distance. Thinner cables will have a smaller gap, and high-end frequencies will bleed to ground with shorter lengths. The only way to compensate for that is to go with a thinner signal conductor, resulting in breakage over time. Our cable uses a 20AWG center conductor and spacing for low capacitance 20-25pF/foot at 15-foot length.

Now that we have some of the basics of how length can affect your tone and overall signal, let's talk about length requirements for performing.

Guitar cable length for gigs.

There are a couple of rules of thumb here.

What is the size of the stage?
What is the required movement needed?

If you're performing on a large stage with your rig WAY behind you, you need longer cables. Gigging musicians often carry a short set and a large set for the run between the pedalboard and amp. I usually recommend having an Instrument Junction Box to tie cables together for super long runs. If you're playing in most ‘bar' stages and don't want to be standing on your cables, then I would recommend 10' cables.

The other factor, which can be a significant issue, is where your beverage is during a performance. If you put a drink on your amp, you must ensure your primary instrument cable can return to the pint glass or can. If you use a mic stand to hold your beverage or keep it by your feet, then it's not an issue.

Movement is something to consider as well. Do you stay in your zone? Do you wander around? If so, then a large cable might be required.

For a typical to average stage, I would recommend a 15' to 20' Standard Cable from pedalboard to amp and a 10' or 15' Snake Head or Standard from board to instrument. If you encounter a large stage, I would recommend carrying a 20' Standard as emergency bonus cable and a Junction Box to double your length from pedalboard to amp.

Guitar cable length for recording.

When recording, you are very much in control of your tone, playing area, etc. Length is generally not an issue unless isolation booths are a long way from the playing area. If so, you can dial the proper tone while sound checking and compensating for cable capacitance with the amp or at the console. Starting with the best-desired tone is the way to go, so finding that perfect length for your ear is ideal but not necessary. Also, the opposite can be helpful; in some cases, you may think your tone is too bright, and an extremely long cable might help with that. That is one of the reasons some players like coiled cables to get that added cable capacitance with guitars with exaggerated highs.

In summary, what is ideal cable length for guitar?

Essentially, where it matters the most is live settings. Understand your average stage size and account for that, with backups lengths and the ability to lengthen if needed. Understand how you navigate your playing area (i.e., grabbing drinks, interacting with your band, etc.). Typically, 10-15 foot length cables are ideal for most stages and ensure excellent tone. Anything over 20 feet might require some adjustments.

Below is a listing of our Recent Articles

Your Rick-O-Sound Not Working?

Here at Rattlesnake Cable Company, we field many calls and emails about the Rickenbacker® Rick-O-Sound feature. Usually, these calls are all related to the Rick-O-Sound (or Ric-O-Sound) functionality not behaving as expected. Over the years, I started to notice a trend in relation to these calls, and wanted to basically create a checklist of reasons why your Rick-O-Sound is not working correctly. Some are obvious, but I'm adding them since I do get calls for this. So here are seven reasons...

Read

Custom Stage Cable Looms

What exactly is a cable loom? What is a Cable Loom? First, we need to address the fact that cable looms are sometimes mentioned with different terminologies. A cable loom is when you have multiple signals wires/cables wrapped in a single weave or 'loom'. Sometimes cable looms are referred to as Cable Snakes, Pedalboard Snake, or Pedalboard Cable Snake. Typically, these are used for Pedalboard Cable Management, from board to amp, but can refer to many other applications, such as IEM, XLR,...

Read

TRS cables vs. TS Cables. What's the difference?

A question this often asked is, “What is the difference between a TRS and a TS cable?” This is a frequent question and has a lot of information associated with it. We wanted to provide some answers to some of the most common questions surrounding this simple yet complex topic. We thought the best approach was to break down the various questions we get since there are several angles to the answer. TRS Cables vs TS Cables The first fundamental to understand is that the underlying cables are...

Read

What Is Rick-O-Sound? And what do you need?

What is the Rickenbacker® Rick-o-Sound (Ricko sound)? On the Deluxe Rickenbacker® models, they introduced the Rick-O-Sound circuit in their instruments. The Rick-O-Sound separates the two pick-ups (bridge and neck) into separate, independent lines that require a TRS (aka Balanced or Stereo) cable. You can then use these individual lines and send them to specific amps, pedal setups, etc., via our TRS to Dual Mono Splitter. This split signal handling is managed via a separate output jack...

Read

How to measure custom patch cables for your pedalboard

I have wanted to write this article for some time. We often get asked, "what is the best way to measure custom patch cables on the pedalboard or pedal line?" We must be both on the same page in regards to measurement points! This article will go into measurement techniques and details about patch cables and plug options. Do patch cables matter? Before we start talking about measuring, let's ask the age-old question, "Do patch cables matter?" I've personally used the cheapest cables on the planet...

Read

Reviews on Google

Justin Tucker
8/29/2022
I have been so impressed with Hank and the Rattlesnake Cable Company. Not only with the absolutely amazing quality with their products (which are truly really amazing), but with the customer service. You will not find better customer service in the music business, or any other business for that matter. There are cable companies out there that make great cables but I guarantee you won't find a better product than anything RCC makes and you for sure won't find better customer service anywhere. After purchasing a TRS splitter and TRS cable from them I am a customer for life. Any cable I need in the future will FOR SURE be a Rattlesnake. But what truly made me appreciate them was when I enquired about a solution to an odd speaker cable need, instead of giving me an answer that could have easily sold me another Rattlesnake cable Hank gave me the advice to not introduce another cable into the chain and stick with my initial solution. That was what really made me know that not only do they make super solid boutique quality products but they are a company that stands on honesty and hard work and puts the customers needs before their own. Hank, you are a true gentleman and you have earned a customer for life. Thank you sir

Matthew Grayson
9/7/2020
Rattlesnake Cable Company is a premiere example of excellence in product quality and business. If you were to ask me what brands best represent the audio industry from here in Montana, Rattlesnake Cable Company would be one of the first to mind. Rattlesnake Cables define cable quality. Prior to using them, the difference between "any old cable" and a "nice" cable was negligible to me, but now I cannot go back to just "any old cable." Rattlesnake cables will hold their own in audio quality, durability, AND asthetic when compared side by side with any high end cable on the market.

Mark Hirschman
7/3/2023
Super cable! Using it on my Oscar Schmidt Ubass. The cable keeps all of the deep, upright bass tones that come from the 'bass ukulele'. I am sure it will only get better as the cable breaks in. Cable weave is definitely wear resistant, a little coarser than I expected, but should last longer than me at this point. Now I see why you might want the 'snake head' version if you keep the cable close to your instrument. Excellent - personalized service. Appreciated the follow up email as well though there were no problems to talk about!

John in Newfane VT just made a purchase!
about 51 minutes ago

Dan in Saint Louis MO just made a purchase!
about 14 minutes ago

Phil in Atlanta GA just made a purchase!
about 8 hours ago

Walter in Taunton MA just made a purchase!
about 21 hours ago

Sean in Oxford MA just made a purchase!
about 19 hours ago

Jeromy in Columbia MO just made a purchase!
about 14 hours ago

Jeffrey in Fresno CA just made a purchase!
about 11 minutes ago

Thomas in Berwyn IL just submitted a custom loom request!
about 22 hours ago

TROY in Los Angeles CA just submitted a custom build request!
about 2 hours ago

Adin in Philipsburg MT just made a purchase!
about 21 hours ago

What is the perfect guitar cable length?