Free US / Domestic Shipping On Orders Over $135!

What is the perfect guitar cable length?

At Rattlesnake Cable Company, we often get asked, "what is the perfect guitar cable length?" That is a difficult question to answer without knowing some of the critical variables and applications for the musician. But before we get started, let's start with some of the common questions.

Are long guitar cables bad?

Yes and no. Typically, extremely long guitar cables can be a problem due to cable capacitance. The longer the run, the more capacitance can be encountered. Cable capacitance will darken or muddy your tone. The rate of that capacitance has multiple factors, including the length of the cable, the gauge of the conductor, and the how much internal insulation separates the signal conductor from the shield.

Long cables can be remedied with a signal buffer to get that original signal back. So if a long cable is required, we recommend using a buffer somewhere in the signal chain.

Does guitar cable affect the sound?

Absolutely, the guitar cable can affect the sound. As I mentioned above, capacitance can be an issue. This is highly dependent on the cables you purchase and how they are built. Shorter run cables in the 10-15 feet range are ideal and going 20 feet and longer, you may begin to experience some tone or signal loss. Our cables are engineered to be low capacitance, with the sweet spot being in that 15' range, and 20' still sounds clear and natural.

What is the perfect guitar cable length? Cable from spool

Are thicker guitar cables better?

Thicker guitar cables tend to indicate durability (beefy, as they say). But thicker cables also mean a more significant gap between the signal conductor and the internal shield. This gap is critical for maintaining lower capacitance over distance. Thinner cables will have a smaller gap, and high-end frequencies will bleed to ground with shorter lengths. The only way to compensate for that is to go with a thinner signal conductor, resulting in breakage over time. Our cable uses a 20AWG center conductor and spacing for low capacitance 20-25pF/foot at 15-foot length.

Now that we have some of the basics of how length can affect your tone and overall signal, let's talk about length requirements for performing.

Guitar cable length for gigs.

There are a couple of rules of thumb here.

What is the size of the stage?
What is the required movement needed?

If you're performing on a large stage with your rig WAY behind you, you need longer cables. Gigging musicians often carry a short set and a large set for the run between the pedalboard and amp. I usually recommend having an Instrument Junction Box to tie cables together for super long runs. If you're playing in most ‘bar' stages and don't want to be standing on your cables, then I would recommend 10' cables.

The other factor, which can be a significant issue, is where your beverage is during a performance. If you put a drink on your amp, you must ensure your primary instrument cable can return to the pint glass or can. If you use a mic stand to hold your beverage or keep it by your feet, then it's not an issue.

Movement is something to consider as well. Do you stay in your zone? Do you wander around? If so, then a large cable might be required.

For a typical to average stage, I would recommend a 15' to 20' Standard Cable from pedalboard to amp and a 10' or 15' Snake Head or Standard from board to instrument. If you encounter a large stage, I would recommend carrying a 20' Standard as emergency bonus cable and a Junction Box to double your length from pedalboard to amp.

Guitar cable length for recording.

When recording, you are very much in control of your tone, playing area, etc. Length is generally not an issue unless isolation booths are a long way from the playing area. If so, you can dial the proper tone while sound checking and compensating for cable capacitance with the amp or at the console. Starting with the best-desired tone is the way to go, so finding that perfect length for your ear is ideal but not necessary. Also, the opposite can be helpful; in some cases, you may think your tone is too bright, and an extremely long cable might help with that. That is one of the reasons some players like coiled cables to get that added cable capacitance with guitars with exaggerated highs.

In summary, what is ideal cable length for guitar?

Essentially, where it matters the most is live settings. Understand your average stage size and account for that, with backups lengths and the ability to lengthen if needed. Understand how you navigate your playing area (i.e., grabbing drinks, interacting with your band, etc.). Typically, 10-15 foot length cables are ideal for most stages and ensure excellent tone. Anything over 20 feet might require some adjustments.

Below is a listing of our Recent Articles

Your Rick-O-Sound Not Working?

Here at Rattlesnake Cable Company, we field many calls and emails about the Rickenbacker® Rick-O-Sound feature. Usually, these calls are all related to the Rick-O-Sound (or Ric-O-Sound) functionality not behaving as expected. Over the years, I started to notice a trend in relation to these calls, and wanted to basically create a checklist of reasons why your Rick-O-Sound is not working correctly. Some are obvious, but I'm adding them since I do get calls for this. So here are seven reasons...

Read

Custom Stage Cable Looms

What exactly is a cable loom? What is a Cable Loom? First, we need to address the fact that cable looms are sometimes mentioned with different terminologies. A cable loom is when you have multiple signals wires/cables wrapped in a single weave or 'loom'. Sometimes cable looms are referred to as Cable Snakes, Pedalboard Snake, or Pedalboard Cable Snake. Typically, these are used for Pedalboard Cable Management, from board to amp, but can refer to many other applications, such as IEM, XLR,...

Read

TRS cables vs. TS Cables. What's the difference?

A question this often asked is, “What is the difference between a TRS and a TS cable?” This is a frequent question and has a lot of information associated with it. We wanted to provide some answers to some of the most common questions surrounding this simple yet complex topic. We thought the best approach was to break down the various questions we get since there are several angles to the answer. TRS Cables vs TS Cables The first fundamental to understand is that the underlying cables are...

Read

What Is Rick-O-Sound? And what do you need?

What is the Rickenbacker® Rick-o-Sound (Ricko sound)? On the Deluxe Rickenbacker® models, they introduced the Rick-O-Sound circuit in their instruments. The Rick-O-Sound separates the two pick-ups (bridge and neck) into separate, independent lines that require a TRS (aka Balanced or Stereo) cable. You can then use these individual lines and send them to specific amps, pedal setups, etc., via our TRS to Dual Mono Splitter. This split signal handling is managed via a separate output jack...

Read

How to measure custom patch cables for your pedalboard

I have wanted to write this article for some time. We often get asked, "what is the best way to measure custom patch cables on the pedalboard or pedal line?" We must be both on the same page in regards to measurement points! This article will go into measurement techniques and details about patch cables and plug options. Do patch cables matter? Before we start talking about measuring, let's ask the age-old question, "Do patch cables matter?" I've personally used the cheapest cables on the planet...

Read

Reviews on Google

Kevin Ferguson
2/23/2021
Been jammin on my cable for a few weeks now, and have nothing bad to say. Though I feel like a dummy for not investing in a decent instrument cable sooner. I definitely plan on upgrading all my cables and connectors to Rattlesnake. Excellent quality, and sound, I'm eager to see how they hold up in... Read

Andrew Gonzales
1/20/2021
I have ordered two instrument cables from Rattlesnake, I am very happy with the experience. The items arrived in a timely manner and the packaging is superb. The quality is amazing, the outer casing of the cords are very durable, and I love that I get to choose the material and angle of the... Read

Spreadster
2/25/2025
Hank and crew at Rattlesnake go out of their way to make sure they support you before, during and after your order. How do I know? Quick story: My new puppy tried to chew a Rattlesnake braided cable, not getting very far, but rendering it useless. Was going to try and splice it due to its value, but instead I sent Hank an email. He not only replaced the cable with a brand new one over a year after I bought it, he even sent doggie chew treats in the box! Are you kidding? Who does this? Top quality gear, best service on the planet, it's Rattlesnake Cable Company, proudly made in USA too.

Travis in Littleton CO just submitted a custom loom request!
about 2 hours ago

Jonny in Haifa Israel just made a purchase!
about 4 hours ago

Scott in Avon OH just submitted a custom build request!
about 2 hours ago

Andrew in Fort Mill SC just made a purchase!
about 14 minutes ago

Robert in Augusta GA just made a purchase!
about 2 hours ago

Anthony in Rock Creek OH just submitted a custom loom request!
about 24 minutes ago

Robert in Mt. Pleasant SC just submitted a custom build request!
about 2 hours ago

Jim in Montfort WI just submitted a custom loom request!
about 7 hours ago

Rusty in Yorba Linda CA just made a purchase!
about 8 minutes ago

Wade in Madison AL just made a purchase!
about 15 hours ago

What is the perfect guitar cable length?