Free US / Domestic Shipping On Orders Over $135!

What is the perfect guitar cable length?

At Rattlesnake Cable Company, we often get asked, "what is the perfect guitar cable length?" That is a difficult question to answer without knowing some of the critical variables and applications for the musician. But before we get started, let's start with some of the common questions.

Are long guitar cables bad?

Yes and no. Typically, extremely long guitar cables can be a problem due to cable capacitance. The longer the run, the more capacitance can be encountered. Cable capacitance will darken or muddy your tone. The rate of that capacitance has multiple factors, including the length of the cable, the gauge of the conductor, and the how much internal insulation separates the signal conductor from the shield.

Long cables can be remedied with a signal buffer to get that original signal back. So if a long cable is required, we recommend using a buffer somewhere in the signal chain.

Does guitar cable affect the sound?

Absolutely, the guitar cable can affect the sound. As I mentioned above, capacitance can be an issue. This is highly dependent on the cables you purchase and how they are built. Shorter run cables in the 10-15 feet range are ideal and going 20 feet and longer, you may begin to experience some tone or signal loss. Our cables are engineered to be low capacitance, with the sweet spot being in that 15' range, and 20' still sounds clear and natural.

What is the perfect guitar cable length? Cable from spool

Are thicker guitar cables better?

Thicker guitar cables tend to indicate durability (beefy, as they say). But thicker cables also mean a more significant gap between the signal conductor and the internal shield. This gap is critical for maintaining lower capacitance over distance. Thinner cables will have a smaller gap, and high-end frequencies will bleed to ground with shorter lengths. The only way to compensate for that is to go with a thinner signal conductor, resulting in breakage over time. Our cable uses a 20AWG center conductor and spacing for low capacitance 20-25pF/foot at 15-foot length.

Now that we have some of the basics of how length can affect your tone and overall signal, let's talk about length requirements for performing.

Guitar cable length for gigs.

There are a couple of rules of thumb here.

What is the size of the stage?
What is the required movement needed?

If you're performing on a large stage with your rig WAY behind you, you need longer cables. Gigging musicians often carry a short set and a large set for the run between the pedalboard and amp. I usually recommend having an Instrument Junction Box to tie cables together for super long runs. If you're playing in most ‘bar' stages and don't want to be standing on your cables, then I would recommend 10' cables.

The other factor, which can be a significant issue, is where your beverage is during a performance. If you put a drink on your amp, you must ensure your primary instrument cable can return to the pint glass or can. If you use a mic stand to hold your beverage or keep it by your feet, then it's not an issue.

Movement is something to consider as well. Do you stay in your zone? Do you wander around? If so, then a large cable might be required.

For a typical to average stage, I would recommend a 15' to 20' Standard Cable from pedalboard to amp and a 10' or 15' Snake Head or Standard from board to instrument. If you encounter a large stage, I would recommend carrying a 20' Standard as emergency bonus cable and a Junction Box to double your length from pedalboard to amp.

Guitar cable length for recording.

When recording, you are very much in control of your tone, playing area, etc. Length is generally not an issue unless isolation booths are a long way from the playing area. If so, you can dial the proper tone while sound checking and compensating for cable capacitance with the amp or at the console. Starting with the best-desired tone is the way to go, so finding that perfect length for your ear is ideal but not necessary. Also, the opposite can be helpful; in some cases, you may think your tone is too bright, and an extremely long cable might help with that. That is one of the reasons some players like coiled cables to get that added cable capacitance with guitars with exaggerated highs.

In summary, what is ideal cable length for guitar?

Essentially, where it matters the most is live settings. Understand your average stage size and account for that, with backups lengths and the ability to lengthen if needed. Understand how you navigate your playing area (i.e., grabbing drinks, interacting with your band, etc.). Typically, 10-15 foot length cables are ideal for most stages and ensure excellent tone. Anything over 20 feet might require some adjustments.

Below is a listing of our Recent Articles

Your Rick-O-Sound Not Working?

Here at Rattlesnake Cable Company, we field many calls and emails about the Rickenbacker® Rick-O-Sound feature. Usually, these calls are all related to the Rick-O-Sound (or Ric-O-Sound) functionality not behaving as expected. Over the years, I started to notice a trend in relation to these calls, and wanted to basically create a checklist of reasons why your Rick-O-Sound is not working correctly. Some are obvious, but I'm adding them since I do get calls for this. So here are seven reasons...

Read

Custom Stage Cable Looms

What exactly is a cable loom? What is a Cable Loom? First, we need to address the fact that cable looms are sometimes mentioned with different terminologies. A cable loom is when you have multiple signals wires/cables wrapped in a single weave or 'loom'. Sometimes cable looms are referred to as Cable Snakes, Pedalboard Snake, or Pedalboard Cable Snake. Typically, these are used for Pedalboard Cable Management, from board to amp, but can refer to many other applications, such as IEM, XLR,...

Read

TRS cables vs. TS Cables. What's the difference?

A question this often asked is, “What is the difference between a TRS and a TS cable?” This is a frequent question and has a lot of information associated with it. We wanted to provide some answers to some of the most common questions surrounding this simple yet complex topic. We thought the best approach was to break down the various questions we get since there are several angles to the answer. TRS Cables vs TS Cables The first fundamental to understand is that the underlying cables are...

Read

What Is Rick-O-Sound? And what do you need?

What is the Rickenbacker® Rick-o-Sound (Ricko sound)? On the Deluxe Rickenbacker® models, they introduced the Rick-O-Sound circuit in their instruments. The Rick-O-Sound separates the two pick-ups (bridge and neck) into separate, independent lines that require a TRS (aka Balanced or Stereo) cable. You can then use these individual lines and send them to specific amps, pedal setups, etc., via our TRS to Dual Mono Splitter. This split signal handling is managed via a separate output jack...

Read

How to measure custom patch cables for your pedalboard

I have wanted to write this article for some time. We often get asked, "what is the best way to measure custom patch cables on the pedalboard or pedal line?" We must be both on the same page in regards to measurement points! This article will go into measurement techniques and details about patch cables and plug options. Do patch cables matter? Before we start talking about measuring, let's ask the age-old question, "Do patch cables matter?" I've personally used the cheapest cables on the planet...

Read

Reviews on Google

Steve Strock
11/26/2022
I was shopping for a cable that would look great with my Taylor 522e. The Black Cherry Rattlesnake cable fit the bill. I have seen Rattlesnake Cables in my two favorite music stores both in Montana. I also wanted to support made in Montana products so this cable is perfect. I have used it twice so... Read

Ansley Wolak
5/19/2025
Hands down, the best cables I’ve used. Just wish my singer would stop trying to steal them.

Jim Lockwood
7/1/2022
I have purchased many cables over the last 30 years of playing. Rattlesnake cables are the absolute best that I've come across. IFrom patch cables to speaker cables to instrument cables: they are all top notch! All my bandmates are now hooked on them as well. We all love that they come in different colors so we know who's cables are who's at the end of the night when wrapping up after a gig. One band member said that he's tried many different brands of cables, but his Rattlesnake cables are the only ones that don't create a hum with his instrument. Being in a band in northwest Montana, we also all appreciate that we are supporting a Montana business! Cheers to Rattlesnake! Keep up the great work!

Ansley Wolak
5/19/2025
Hands down, the best cables I’ve used. Just wish my singer would stop trying to steal them.

Jeffrey in Asheville NC just made a purchase!
about 1 day ago

Gordon in Fountain Valley CA just made a purchase!
about 12 hours ago

Greg in Murfreesboro TN just submitted a custom loom request!
about 7 hours ago

Trae in Rougemont NC just made a purchase!
about 1 day ago

Stuart in Lincoln MT just made a purchase!
about 20 hours ago

Thaddeus in Waco TX just made a purchase!
about 1 day ago

BRANDON in Poolville TX just made a purchase!
about 18 hours ago

Jonathan in Holland MI just submitted a custom loom request!
about 1 day ago

Chris in Bozeman MT just made a purchase!
about 2 hours ago

Matthew in Clovis NM just submitted a custom build request!
about 23 hours ago

What is the perfect guitar cable length?